1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Poorly Pawls - Hope Pro 2 Rear Hub & Freehub Body Bearing Replacement

Discussion in 'Maintenance' started by Greg, Nov 19, 2015.

  1. Greg

    Greg MTB Rider Staff Member

    A few pics of Chris's single speed setup Hope Pro2 bearing replacement from Monday evening.
    There was a lot of play in the Freehub Body and the Drive Side Seal was extremely badly worn and no longer preventing contamination entering. Once stripped and cleaned it was clear that the pawls and springs were heavily worn too and would require replacing.

    P1010333.jpg

    P1010334.jpg

    P1010337.jpg
    Worn Drive Side Seal

    P1010339.jpg

    P1010340.jpg
    The top pawl is how they should look, lower one is heavily work
     
  2. Greg

    Greg MTB Rider Staff Member

    P1010331.jpg
    Nice and clean with the drive side bearing pressed in.

    P1010347.jpg
    Outer Freehub bearing had all but collapsed...

    P1010348.jpg
    ...and disintegrated on removal.

    P1010327.jpg
    All new bearings (not gen Hope) only had minimal grease applied.

    P1010328.jpg
     
  3. Greg

    Greg MTB Rider Staff Member

    P1010330.jpg
    Additional grease applied to help extend the bearing life as this bike is used daily in all conditions, both commuting and off road.

    P1010351.jpg
    Assembled Freehub awaiting new pawls and springs.
     
  4. chris obrien

    chris obrien Active Member

    crikey ,like you say ,another month and that would have given up altogether and no drive , pawls and springs with seal arrived today ,will put them in tonight ,cheers for post
     
  5. Greg

    Greg MTB Rider Staff Member

    You certainly got the most out of those bearings though!!
     

Share This Page